Toto EGO II Quick Start Manual

SPECIFICATIONS
120 120
Ø54
Ø91
G½
OPERATING CONDITIONS
1. Water supply pressure : 0.05 ~ 0.75 MPa.
2. Ensure that water supply is clean ( No Sand, Dirt, Etc.).
ATTENTION
1.
Don t use abrasive cleaners or solvents on faucets and
fittings.
2. As the product model is constantly updated, the actual
product may not look the same as it shown in the diagram,
but the basic installation principles are the same.
MAINTENANCE
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and
are not recommended for cleaning
S06427RR
"EGO II" LEVER HANDLE MIXING VALVE FOR BATH
INSTALLATION
1.
G½
Hot Water
Supply *
To Bath Spout *
G ¾
* Pipe supplied by owner
2.
O-Ring
Cover *
* Remove the cover & O-ring after the mortar dry
3.
Handle *
w/ Color
* The red handle for left position and the blue handle
for right position.
**Tighten the handle base by hand
& SHOWER W/ DIVERTER
4.
Minimum Mortar Level
Maximum Mortar Level
To Shower *
* The colorless handle for center position.
**Tighten the handle base by hand
Cold Water
TROUBLESHOOTING
Supply *
Water leaks around the handle
Mortar
Handle Base**
TX469SEL
Flange
Handle*
w/o Color
Handle Base **
CHECK
SOLUTION
PROBLEM
POINT
1 Tighten
1. CERAMIC
HEAD WORK
R8