Page 1
MK1 - Quick Guide ® INSTALL THE CHARGING STATION BUS COMMUNICATION WIRING INSTALL THE CLU CONFIGURATION COMPLETE THE INSTALLATION LABELING DEFA CLU MK1 - Quick Guide Version 1.1...
Page 2
L3 N * The CPPS is a datasheet which describes how phase distribution, addresses etc. in a CLU facility must be configured. It is includet with every CLU configuration and distributed by DEFA DEFA CLU MK1 - Quick Guide Version 1.1 DEFA CLU MK1 - Quick Guide Version 1.1...
BUS IN BUS OUT BUS IN BUS OUT DEFA CLU MK1 - Quick Guide Version 1.1 DEFA CLU MK1 - Quick Guide Version 1.1...
Page 4
Treminal 6 incorrect wiring. *For other combinations, see CLU MK1 installation manual chapter 9. * The CLU only supports a specific type of three-phase and single-phase energy meters and is not compatible with any other suppliers. Contact DEFA for specifications.
Page 5
NOTE: Make sure to place the through a LAN cable. antenna where there is sufficient reception. Connect the USB-RS232 to one of the four USB ports on the CLU. DEFA CLU MK1 - Quick Guide Version 1.1 DEFA CLU MK1 - Quick Guide Version 1.1...
Configuration HOW TO INSERT THE SIM CARD INTO THE MODEM: Install the DEFA Charge Point Configurator (CPC) on a Windows computer or Android smartphone. Connect the configuration kit to the bus or an individual charge point, and a unit with the CPC software installed.
Page 7
Make sure that Baud rate is set to 38400, parity is set to NONE and stop bits are set to 1. Click Write to save settings. DEFA CLU MK1 - Quick Guide Version 1.1 DEFA CLU MK1 - Quick Guide Version 1.1...
Page 8
HOW TO LABEL AN ERANGE UNO FOR test box. CloudCharge OR LADE I NORGE: Connection to CloudCharge ® can be confirmed by contacting DEFA support. DEFA test box for charging station. Art.nr.: 710253 DEFA CLU MK1 - Quick Guide Version 1.1 DEFA CLU MK1 - Quick Guide Version 1.1...
Page 9
• Hvor fort kan jeg lade her? • Jeg får ikke ladet - hvorfor ? www.ladeinfo.no ELISABETH LINA til 59 44 15 56 til 59 44 15 56 25 mm 25 mm 106 mm 43 mm 43 mm DEFA CLU MK1 - Quick Guide Version 1.1...
Need help?
Do you have a question about the CLU MK1 and is the answer not in the manual?
Questions and answers