MSI MS-6151 Manual page 21

Step 3: Install the MSI Heat Sink (optional) to the Processor.
TM
Celeron
processor
Push down the plastic clips, so that they are in line with the hole on
the processor. Check for perfect fit.
Step 4: Install the Processor.
Insert the Processor like inserting a PCI or an ISA card.
Step 5: Lock the Processor
Notch
Hole
Lock the processor by putting the Retention Cap provided. Take
note of the two plastic lock at the side of the Retention Cap. This
two plastic lock should be aligned properly into the Retention
Mechanism notch hole.
The instruction procedure may
vary depending on the Heat Sink
that you're using.
plastic Clip
Retention Cap
2-15
Heat Sink
Plastic
Lock
Notch
Hole