Yamaha WR250X 2007 Owner's Manual page 86

MOTORCYCLE CARE AND STORAGE
fuel from deteriorating.
3. Perform the following steps to pro-
tect the cylinder, piston rings, etc.
from corrosion.
1 a. Remove the spark plug cap
and spark plug.
b. Pour a teaspoonful of engine oil
2
into the spark plug bore.
c. Install the spark plug cap onto
3
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
4
grounded. (This will limit spark-
ing during the next step.)
5
d. Turn the engine over several
times with the starter. (This will
6
coat the cylinder wall with oil.)
e. Remove the spark plug cap
from the spark plug, and then
7
install the spark plug and the
spark plug cap.
8
WARNING
9
To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turning
the engine over.
4. Lubricate all control cables and the
pivoting points of all levers and
pedals as well as of the sidestand/
centerstand.
5. Check and, if necessary, correct
the tire air pressure, and then lift
the motorcycle so that both of its
wheels are off the ground. Alterna-
tively, turn the wheels a little every
month in order to prevent the tires
from becoming degraded in one
spot.
6. Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
7. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a month.
Do not store the battery in an ex-
cessively cold or warm place
[less than 0 °C (30 °F) or more
than 30 °C (90 °F)]. For more in-
EWA10950 formation on storing the battery,
see page 6-31.
NOTE:
Make any necessary repairs before
storing the motorcycle.
7-4