Yamaha WR250X 2007 Owner's Manual page 28

INSTRUMENT AND CONTROL FUNCTIONS
rebound damping force and thereby
soften the rebound damping, turn the
adjusting screw on each fork leg in di-
rection (b).
1
Rebound damping setting:
Minimum (soft):
2
24 click(s) in direction (b)*
Standard:
10 click(s) in direction (b)*
3
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned
4
in direction (a)
5
Compression damping force
1. Remove the rubber cap by pulling
6
it out of the front fork leg.
7
8
1
9
1. Rubber cap
2. To increase the compression
damping force and thereby harden
the compression damping, turn the
adjusting screw on each fork leg in
direction (a). To decrease the
compression damping force and
thereby soften the compression
damping, turn the adjusting screw
on each fork leg in direction (b).
(b)
(a)
1
1. Compression damping force adjusting
screw
3-14
Compression damping setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
10 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned
in direction (a)
3. Install the rubber cap.
CAUTION:
Never attempt to turn an adjusting
mechanism beyond the maximum or
minimum settings.
NOTE:
Although the total number of clicks of a
damping force adjusting mechanism
may not exactly match the above spec-
ifications due to small differences in
production, the actual number of clicks
always represents the entire adjusting
range. To obtain a precise adjustment,
it would be advisable to check the num-
ber of clicks of each damping force ad-
justing mechanism and to modify the
specifications as necessary.
ECA10100