Factory Setting; Switching On The Appliance; Time Preselection; Programme End - Siemens iQ700 SN Series Instruction Manual

aus Operating the appliance

Factory setting

You can reset all settings to the factory
setting.

Switching on the appliance

Turn tap fully on.
1.
Switch on ON/OFF switch (.
2.
The displays for the last programme
and last additional function selected
flash. These settings will be retained
unless another 0 programme key
is pressed.
Press the START button h.
3.
Programme sequence starts.
Time Delay
You can delay the start of the
programme by up to 24 hours.
Depending on the setting of the time
display, the end of programme is
indicated with "Finish in" (for example
3h 25m) or "Finish at" (for example
15:20 hours).
Open the door.
1.
Switch on ON/OFF switch (.
2.
Selects programme 0.
3.
Press time preselection button X.
4.
Keep pressing the setting buttons + -
5.
P until the displayed time
corresponds with your requirements.
Press START button h, timer
6.
programming is activated.
To delete the time preselection,
7.
press START button h for approx.
3 seconds.
Time preselection was terminated.
Close the door.
8.
32

Programme end

* The programme has ended when
"Finished" is indicated on the display
window at the top @ and on the front
display * )2.
* The end of the programme is
displayed on the floor – provided the
TimeLight (optical display) is switched
on and is visible.
* depending on the features of your
dishwasher

Switching off the appliance

Short time after the end of the
programme:
Open the door.
1.
Switch off ON/OFF switch (.
2.
Turn off tap (does not apply to
3.
appliances with Aqua-Stop).
Remove the utensils when they have
4.
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.