Presetting Radio Stations - Sony Walkman D-FJ003 Operating Instructions

Remaining battery power SOUND/AVLS
Bookmark
 (headphones)
jack
Play mode
MONO
LOCAL Headphones
P MODE/
PRESET
VOL +*/–
Band
OPEN
Track number/
Preset number HOLD (rear)
Playing time/Frequency
RADIO ON/ BAND
Sound mode
Power Sources Playing a CD
1 Slide OPEN to open the lid and fit the CD to the pivot,
To use the batteries (not supplied)
then close the lid.
1 Slide OPEN to open the player lid and open the battery
2 Press .
compartment lid inside the CD player. To play from the first track, press  for 2 seconds or
2 Insert two LR6 (size AA) alkaline batteries by matching
more while the CD player is stopped.
the  to the diagram inside the CD player and close the
• This CD player can play CD-Rs/CD-RWs recorded in
lid until it clicks into place. Insert the  end first (for
the Compact Disc Digital Audio (Audio CD) format,
both batteries).
but playback capability may vary depending on the
quality of the disc and the condition of the recording
Battery life* (approx. hours)
device.
• This product is designed to play back discs that
(When the CD player is used on a flat and stable place.)
Playing time varies depending on how the CD player is used. conform to the Compact Disc (CD) standard.
Recently, various music discs encoded with copyright
G-PROTECTION G-on G-off RADIO
protection technologies are marketed by some record
ON
companies. Please be aware that among those discs,
there are some that do not conform to the CD standard
Two Sony alkaline batteries LR6
16 11 35
and may not be playable by this product.
(SG) (produced in Japan)
Note on DualDiscs
* Measured value by the standard of JEITA (Japan
A DualDisc is a two sided disc product which mates DVD
Electronics and Information Technology Industries
recorded material on one side with digital audio material on
Association).
the other side. However, since the audio material side does
• The indicator sections of roughly show the
not conform to the Compact Disc (CD) standard, playback
remaining battery power. One section does not always
on this product is not guaranteed.
indicate one-fourth of the battery power.
Digital MEGA BASS function
To use the AC power adaptor (not supplied)
During play, press SOUND/AVLS repeatedly to select
Connect the AC power adaptor as illustrated.
"SND 1" or "SND 2."
If the sound is distorted, turn down the volume.
While listening to the radio, this function is disabled.
AVLS* function
*Automatic Volume Limiter System
Press and hold SOUND/AVLS.
If "AVLS" flashes three times, the function is enabled.
If "AVLS" flashes once, the function is disabled.
You can also use this function while listening to the radio.
AMS* / search function
*Automatic Music Sensor
Display
To find the beginning of the previous/current/next/
DC IN 4.5 V
succeeding track(s): Press / repeatedly.
To go backward/forward quickly: Press and hold /.
to an AC outlet
Play mode function
During play, press P MODE/ repeatedly:
No indication (normal play)  "1"(single track play) 
AC power adaptor
"SHUF"(shuffle play)  "
"(Bookmark play)
To repeat the play mode you selected, press and hold
/ • TUNE –/+
P MODE/ until " " appears.
*(play/pause)/
G-PROTECTION function
ENTER
The function provides protection against sound skipping
 (stop) • RADIO OFF
during many active uses.*
The default setting is "G-on." To select "G-off," press 
while you keep pressing  during stop. To enjoy high
* The button has a tactile dot.
quality CD sound, select "G-off".
* Sound may skip: if the CD player receives stronger
continuous shock than expected / if a dirty or scratched
CD is played / when using poor-quality CD-Rs/CD-RWs
or if there is a problem with the recording device or
application software.
Bookmark play
If you add Bookmarks to your favorite tracks, you can listen
to these tracks only from the track with the lowest number.
1 During playback of the track where you want to add a
Bookmark, press and hold  until "
flashes on the display.
2 Repeat step 1 to add Bookmarks to the tracks you want.
3 Press P MODE/
repeatedly until "
4 Press .
To remove the Bookmarks
During playback of the track with a Bookmark, press and
hold  until "
" disappears from the display.
If you change CDs and start playing, all the Bookmarks
added for the previous CD will be erased.
Listening to the Radio
1 Press RADIO ON/BAND to turn on the radio.
If "PRESET" appears on the display, press P MODE/
to make "PRESET" disappear from the display.
2 Press RADIO ON/BAND until the band you want
appears.
Each time you press the button, the display changes as
follows:
 FM  AM
3 Press TUNE + or - to tune in the station you want and
adjust the volume.
Turning off the radio
Press  • RADIO OFF.
Tuning in the station quickly
Press and hold TUNE + or - in step 3 until the frequency
digits begin to change on the display. The CD player
automatically scans the radio frequencies and stops when it
finds a clear station.
Improving broadcast reception
For FM, extend the headphones cord.
Headphones
For AM, reorient the CD player itself.
Note
Keep the headphones connected to the  jack of the CD
player. The headphones cord works as the FM antenna.
If it is hard to hear the FM broadcast due to
interference from strong radio waves
1 While listening to the FM broadcast, press SOUND/
AVLS.
"LOCAL" flashes.
(Bookmark)" 2 Press /ENTER within 10 seconds after you finished
the previous operation.*
"LOCAL" stops flashing.
" flashes. * If "LOCAL" disappears from the display, start from
Step 1.
To cancel the LOCAL setting, press SOUND/AVLS, and
then press /ENTER so that "LOCAL" disappears from
the display.
If it is hard to hear the FM broadcast due to
poor reception
1 While listening to the FM broadcast, press SOUND/
AVLS.
"LOCAL" flashes.
2 Press SOUND/AVLS again.
"MONO" flashes.
3 Press /ENTER within 10 seconds after you finished
the previous operation.*
"MONO" stops flashing.
* If "MONO" disappears from the display, start from Step 1.
To cancel the MONO setting, press SOUND/AVLS twice,
and then press /ENTER so that "MONO" disappears
from the display.

Presetting Radio Stations

You can preset up to 30 stations: 20 for FM and 10 for AM.
1 While listening to the radio, press P MODE/
to enter
the preset mode.
"PRESET" appears on the display.
2 Press TUNE + or - repeatedly until the preset number you
want appears on the display.
3 Press and hold P MODE/
until "PRESET" flashes on
the display.
From this step on, start the next operation within 30
seconds after you finished the previous operation. If
"PRESET" stops flashing, start from step 3.
4 Press TUNE + or - repeatedly to tune in the station you
want.
5 Press /ENTER.
To cancel all preset stations
1 While the radio is turned off and CD play is stopped,
press RADIO ON/BAND while you are pressing .
"CLEAr" flashes.
2 Press /ENTER.
Playing Preset Radio
Stations
1 Press RADIO ON/BAND to select the band.
2 When "PRESET" does not appear on the display, press
P MODE/ to enter the preset mode.
"PRESET" appears on the display.
3 Press TUNE + or - to tune in a stored station.
Changing the Tuning
Interval
When using the CD player abroad, change the AM tuning
interval, if necessary.
9 kHz area: Asia and Europe
10 kHz area: the U.S.A., Canada and Latin America
1 While the radio is turned off and CD play is stopped,
press RADIO ON/BAND while you are pressing .
If the current setting is "9 kHz," "10 kHz" flashes on the
display.
If the current setting is "10 kHz," "9 kHz" flashes on the
display.
2 Press /ENTER.
Note
After changing the tuning interval, you need to preset radio
stations again.