Cutting Of Pole; Attachment And Anchorage; Electrical Connection - MIMSAL MS CEILING Manual

10. CUTTING OF POLE

Instructions for cutting the mast to adapt the support
length to the height of the ceiling:
1. Remove the 3 screws (1).
2. Take the pole out, separating it from part (2) .
3. Cut the pole to the desired measurement.
4. Make the three holes of the same measurement in the pole (3).
5. Assemble and insert screws.

11. ATTACHMENT AND ANCHORAGE

Position the support on the ceiling and mark the 5 support holes
to install the attachment.
The attachment calculations shall be the
responsibility of the Structures Technician.

12. ELECTRICAL CONNECTION

1. Insert the cable into the bottom of the pole.
(Cable protection according to regulations).
2. Connect the cable to the power network using standardized
protected connectors.
3. Conceal the connectors inside the pole or in the upper part.
Ø 250mm
Ø 230mm
Ø 5 X 8,5mm
ENG