1. Flywheel brake lever
2. Bracket
11.
Using the supplied cable ties, secure the cable
to the handlebar upper and lower sections.
12.
Operate the machine and ensure that the
operator-presence bail shuts off the machine
when it is released; refer to the HoverPro
Operator's Manual.
Important:
When you release the
operator-presence bail, both the engine and
cutting disc should stop within 3 seconds.
If they do not stop properly, stop using
your machine immediately and contact an
Authorized Service Dealer or authorized Toro
distributor.
Note:
Use care when maneuvering the
machine, the longer handle may make
maneuvering more difficult.
Be careful when moving or storing the unit to
prevent the latching mechanism from breaking.
Figure 5
3. Brake control cable
4. Loose cable fitting
g018582
3