Advertisement
The receiver can be paired with 8 different transmitters (remote buttons).
Pairing with more buttons will remove the first entries made.
Unpairing
To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it
down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory
of the controller has been cleared.
Local buttons
Short press of a button switches the relay in to the opposite state.
Long press of a button (longer than 5 second) activates the relay regardless of the state, in which
the relay was previously in. This feature can be used for synchronizing a group of receivers con-
nected to the same local button. Releasing the button sets the relay in the on position.
Remote buttons
The FW-RC4, FW-RC10 transmitters operate on the principle of a bistable switch: one
press of a button activates the relay; the second press of button deactivates the relay.
The FW-RC5 transmitter also has separate inputs ON (always ON) and OFF (always
OFF).
Due to the nature of transmission and retransmission do not use the same button in
transmitter more often than every 2 seconds. Switching of the receiver may be carried
out with a short delay.
We do not recommend the use of remote bistable transmitters to control
a group of receivers due to the possibility of desynchronization of the activation state
(especially when operating on larger distances and/or simultaneous use of local but-
tons on the receivers).
Activation of the thermal protection is indicated by a steady pulsing of communication
LED, switching off of the output circuit and the lack of its reactivation possibility. After
lowering the temperature to a safe value the output circuit will remain switched off
until restarted.
- 4 -
Advertisement
