Installation; Installation For Model A - Dahua Lite DHI-XVR4104/08/16HS-S2 Instruction Manual

3 Installation

Dome camera mainly uses ceiling installation; installation surface includes ceiling and wall.
Attention:

Please install the device in time after it is taken apart, which is to avoid the camera
module being exposed to damp environment for too long.

Before the installation, please make sure the installation surface is thick enough to
sustain at least 3X weight of the camera.

For the installation mode of side cable outlet, it has to pull the cable through the
outlet cable slot on the pedestal and then tighten the screws.

Please do not remove the electrostatic absorbed film on the surface of transparent
cover before installation debugging is over, which is to avoid damage during
installation; please do not touch the dome cover in order to avoid leaving a mark
after the absorbed film is removed.

The installation figures below are for reference only.

3.1 Installation for Model A

Step 1
Hold the decoration ring tightly and unscrew the pedestal anticlockwise.
Step 2
Confirm the installation location and dig holes on the installation surface.
Step 3
Use tools to insert expansion bolts into the installation holes and fix them firmly.
Step 4
Adjust pedestal location (if it is side cable outlet, then pull the cable through the side outlet
cable slot). Align the bolt fixing holes of the device pedestal with the expansion bolt fixing holes
Figure 3-1
5