Cisco 2504 Getting Started Manual page 19

Start the PC terminal emulation program.
Step 2
Configure the terminal emulation program for the following parameters:
Step 3
•
•
•
•
•
Securing the Power Adapter Cable
To secure the power adapter cable to the 2504 controller, use the plastic relief clip shipped with the cable.
The clip relieves the cable in the event it falls and prevents the connector from being sheared off at the
plug pins.
Caution If the relief clip is not installed, the power connector can be damaged if the power cable is pulled or if
the power adapter falls.
Note The Cisco 2106 power adapter is not compatible with a 2504 controller.
To secure the power adapter cable and plug, follow these steps:
Wrap the power adapter cable through the plastic security clip as shown in
Step 1
Figure 11
Fasten the security clip with a screw to the existing hole on the back panel on the 2504 controller (see
Step 2
Figure
9600 baud
8 data bits
No flow control
1 stop bit
No parity
Plastic Relief Clip
12).
Cisco 2500 Series Wireless Controller Getting Started Guide
Installing the Controller
Figure 11.
19