Table of Contents
Advertisement
Software Upgrade and
Licences
Auto Upgrade
When Auto Upgrade is set to On, the television will
automatically upgrade while in standby if new software is
available.
a
From the SETUP menu, press
Software Upgrade and press
b
B
b
Press
or
to select Over-the-air Upgrade and
Q
press
.
c
B
b
Press
or
to select Auto Upgrade.
d
C
c
Use
or
to select On or Off.
Searching for New Software
If preferred, software upgrades can be searched for manually
using Search for New Software.
a
In the Software Upgrade menu, select Over-the-air
Upgrade, and then press
New Software.
b
Q
Press
. The television will automatically start
searching for a software upgrade, the progress bar will
move along the line.
SEARCHING FOR NEW SOFTWARE
Searching for a new software upgrade for this TV.
Searching
If an upgrade is found, the television will automatically
start downloading. If not, a screen will appear stating
that an upgrade is unavailable.
Software Licences
The Licences for the software used in this television are available
for viewing.
a
In the SETUP menu, press
Licences and press
A screen will appear displaying all the licensing
information required for the televisions software.
B
b
or
to select
Q
.
B
b
or
to select Search for
B
b
or
to select Software
Q
.
System Information and
Reset TV
System Information
This feature can be used to check the version of software
currently installed. When in DTV mode, it includes additional
diagnostic information such as signal strength, signal quality,
centre frequency, modulation, etc.
a
From the SETUP menu, press
Information.
b
Q
Press
to display the System Information.
System Information
2.1.26.0 Feb 19 2010 - 15:56:50 FW:13
WEAK
Ch22
Ch25
Ch35
Ch46
c
For information about the signal quality of a particular
multiplex, press
d
Q
Press
for a screen showing detailed technical
information about the selected multiplex.
Selecting Reset TV will reset all TV settings, including saved
channels, to their original factory values.
a
In the SETUP menu, press
highlighted.
b
Q
Press
to select. A screen will appear warning that
all settings will be lost. Press
When the set powers back on, the Quick Setup screen
will appear. Press
perform an auto tune. (See 'Quick Setup' section on
page 14.)
59
CONTROLS AND FEATURES
B
b
or
to select System
TOSHIBA
2010
AVERAGE
STRONG
B
b
or
to select that multiplex.
Reset TV
b
until Reset TV is
Q
to continue.
Q
to advance the setup and
Poor
Good
Good
Good
Advertisement
Table of Contents
