Table of Contents
Advertisement
The Auto Dialler has an 8 amp volt free contact relay output which can be used to switch
on external electric devices such as lighting, sirens etc.
By texting the unit you can turn the relay ON or OFF. Below are examples on how to do
this.
#REL=ON#
This will turn ON relay output
#REL=OFF#
This will turn OFF relay output
After each operation the unit will reply with a status report
It is possible to pulse the output relay for a period of 20 seconds. You will need to send a
text as follows.
#PULSE=REL#
The Relay can be set to automatically pulse for 17 seconds when an input has been
triggered. Please be aware of any conflicts this may cause if you are already using relay
2 as an independently activated relay. To turn this function on, please send the text
command:
#AUTO=ON#
This will turn the auto function on for relay on
#AUTO=OFF#
This will turn the auto function OFF for the relay (default setting is
off)
To reset the unit back to factory settings you will need to send the text message
#RESET#
WARNING - This will reset all of your parameters. ONLY send this command when
necessary.
www.gsm-activate.co.uk
How to Use the Relay Output
Auto Relay Trigger Input On
This will Pulse the relay for 20 seconds.
Auto Relay Trigger Input On
Resetting the Unit
Page 7
- 01273462380 - sales@gsm-activate.co.uk
(see below)
"RELAY ON/OFF"
Advertisement
Table of Contents
