Table of Contents
Advertisement
How to Program the SMS Text Message
You can now change the alarm message for inputs 2, 3 & 4 to your own choosing allowing
you to know which input has been triggered.
To change the message send the text command as follows.
#MESS1=YOUR
MESSSAGE#
#MESS2=YOUR
MESSSAGE#
#MESS3=YOUR
MESSSAGE#
#MESS4=YOUR
MESSSAGE#
This will change the message to "Your Message"
You can only use a maximum of 19 character including spaces for your customised message.
The Auto Dialler can be programmed to send you a telephone call after each text alarm has
been sent.
You will receive approximately three ring tones. The unit will then hang up automatically. This
is to prevent call charges being incurred.
To set the call alert to ON please send the text message
#CALL=ON#
The unit will relay back with "CALL ON"
If the call function has been set to ON you will receive a text message and shortly after, a
phone call.
To disarm the call alerts please send the text message
#CALL=OFF#
INPUT 1 is used with the speech module and operates differently to the other inputs.
Please see page 8 for more information
www.gsm-activate.co.uk
The default message is - "Alarm not Acknowledged"
The default message is - Input 2 activated
The default message is - Input 3 activated
The default message is - Input 4 activated
IMPORTANT - PLEASE READ
Telephone Call Alerts
IMPORTANT - PLEASE READ
Page 5
- 01273462380 - sales@gsm-activate.co.uk
Advertisement
Table of Contents
