Installing The Fan - Hinkley HOVER FLUSH Instruction Manual

INSTALLING THE FAN

REMEMBER to turn off the power. Follow the steps below to hang your
fan properly.
Place the decorative ring onto the motor housing.
Carefully lift fan motor assembly (without the blades) into position by
hanging the motor assembly onto the hook from the ceiling adapter
plate allowing it to hang freely. (Fig. 1)
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the safety
cable from the fan. Loop the safety cable around the wood screw
that was just attached to ceiling joist. Feed the end of the cable
into the clamp and pull as much cable through as possible. Firmly
tighten screw in the clamp. Cut off excess cable. (Fig. 2)
You are now ready to make the electrical connections.
06 | hinkley.com
Outlet Box
Decorative
ring
Fig. 1
Wood Ceiling Joist
Safety Cable Clamp
Safety Cable Loop
Wood Screw
And Washer
Safety Cable
Fig. 2
Hook