Storing The Machine In The Vertical-Stow Position - Toro Recycler 21467 Operator's Manual

Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to
(page 13).
3. Disengage the handle locks
Figure 18
4. Fold the handle fully forward; refer to
the Handle (page
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
Adjusting the Cutting Height
(Figure 18).
Folding
18).
(Figure 19).
g335482
19
Figure 19
g251586