Table of Contents
Advertisement
Cleaning Under the
Machine
Service Interval: After each use
For best results, clean the machine soon after you
have completed mowing.
1.
Move the machine onto a flat paved surface.
2.
Remove the electric-start button and wait for
all moving parts to stop before leaving the
operating position.
3.
Remove the battery pack; refer to
Battery Pack from the Machine (page
4.
Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Folding the Handle
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cable(s) when folding or unfolding the handle.
• Ensure that the cable(s) are routed to the outside of the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1.
Hold the handle while disengaging the handle locks to avoid pinching your hands.
2.
Disengage the handle locks until you can move the upper handle freely (A of
3.
Fold the handle forward to the fully forward position (B of
Important:
Route the cables to the outside of the handle locks as you fold the handle.
4.
To unfold the handle, refer to
Cleaning Under the Machine in the
Vertical-Stow Position
Removing the
16).
Figure 17
2 Unfolding the Handle (page
18
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5.
Start the motor and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
6.
Shut off the motor, remove the electric-start
button, and store the machine; refer to
(page
22).
1.
Set the machine in the vertical-stow position;
refer to
Storing the Machine in the Vertical-Stow
Position (page
19).
2.
Wash out the clippings from under the machine.
Figure
17).
9).
Storage
Figure
17)
g334367
Advertisement
Table of Contents
