Table of Contents
Advertisement
4.
To unfold the handle, refer to
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1.
Remove the electric-start button and battery
from the machine.
2.
Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to
(page
13).
3.
Disengage the handle locks
4.
Fold the handle fully forward; refer to
the Handle (page
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
2 Unfolding the Handle (page
Adjusting the Cutting Height
(Figure
19).
Figure 19
Folding
18).
Figure 18
9).
5.
Engage the handle locks.
6.
Lift the front of the machine by the handle and
move it into a storage space
g459226
19
(Figure
20).
Figure 20
g459225
g251586
Advertisement
Table of Contents
