Storing The Machine In The Vertical-Stow Position - Toro Recycler 21327 Operator's Manual

Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Height (page 13).
3. Disengage the handle locks and fold the handle
fully forward; refer to
17).
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
4. Engage the handle locks.
5. Lift the front of the machine by the handle and
move it into a storage space
Figure 17
Adjusting the Cutting
Folding the Handle (page
(Figure 17).
g409126
18