Table of Contents
Advertisement
Adjusting the Cutting Height
DANGER
Adjusting the height-of-cut could bring your hands into contact with a moving blade and
result in serious injury.
• Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting
the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
Adjust the cutting height as desired. Set all wheels to the same cutting height
During Operation
Starting the Machine
1.
Ensure that the battery pack is installed in the machine; refer to
Note:
If the battery-compartment lid does not close completely, the battery is not fully installed.
2.
Insert the electric-start button into the electric-start switch (A of
3.
Squeeze the blade-control bar and hold it to the handle (B of
4.
Press the electric-start button and keep it pressed until the motor starts (C of
Figure 9
Installing the Battery Pack (page
Figure
Figure
13
(Figure
9).
10).
10).
Figure
10).
g254131
12).
Advertisement
Table of Contents
