Symptom
Vibrates excessively
or makes noise.
Stops.
The ECO TUB CLEAN
alarm does not turn
off.
WA4700NH_DC68-03980A-00_EN.indd 37
WA4700NH_DC68-03980A-00_EN.indd 37
•
Make sure the washing machine is set on a level floor. If the
floor is not level, use the levelling feet to adjust the washing
machine.
•
Make sure the washing machine is not contacting any other
object.
•
Make sure the laundry load is balanced.
•
Make sure the laundry is spread evenly in the washing
machine. Spread out the laundry evenly and start again.
•
Make sure the space around the washing machine is free of
objects.
•
Humming is produced normally during operation.
•
Objects such as coins can cause noise. Remove these objects
from the washing machine after washing is complete.
•
Plug the power cord into a live electrical outlet.
•
Check the fuse or reset the circuit breaker.
•
Close the door, and press or tap START/PAUSE to start the
washing machine. For your safety, the washing machine will
not spin unless the door is closed.
•
Before the washing machine starts to fill, it will make a series
of clicking noises to check the door lock and does a quick
drain.
•
There may be a pause or soak period in the cycle. Wait briefly
and the washing machine may start.
•
Make sure the inlet hose screens at the taps are not clogged.
Periodically clean the screens.
•
This symptom occurs temporarily due to low voltages, and
will be solved when power recovers.
•
When the machine is diagnosed to be cleaned, the
indicator blinks for an hour. This recurs 6 consecutive times
until you run the ECO TUB CLEAN cycle. This is normal, and
not a system failure. To keep the tub clean, it is recommended
to run the cycle once every 1-3 months.
Action
English 37
2018-07-17
2018-07-17
3:06:57
3:06:57