Table of Contents
Advertisement
1. There is a water conduit at the bottom of the freezer, when defrosting, extract the rubber cover,
defrosted water will drip into the hole and flow out.
(NOTES: PLEASE KEEP THE RUBBER COVER WELL DURING THE DEFROSTING AND PUT IT BACK AFTER DEFROSTING IS DONE)
2. Extract the water conduit by 20-25mm until the water hole can be seen.
3. Twist the water conduit until the arrow points downward.
4. After defrosting is done, make sure there is no more water coming out before out the water conduit
in place and make the arrow point upward.
Important Notes:
•
Do not use pointed or sharp-edged objects such as knives or forks to remove the frost.
•
Never use hairdryers, electrical heaters or other such electrical appliances for defrosting.
8. Cleaning and Care
How to Replace Lamp –
•
Product have 240VAC /15W lamp in selected model - SCR-CH 200H*/ 300H* only.
1. Disconnect power supply cord.
2. Remove lamp cover carefully and replace the lamp.
Remarks : Be care full while replacing lamp , you may get injured from touching hot lamp.
** We recommend that you Switch OFF the freezer at the socket outlet and pull out the mains plug
before cleaning.
** Never use any sharp abrasive instrument, soap, household cleaner, detergent and wax polish for
cleaning.
** Use lukewarm water to clean the cabinet of the freezer with a cloth and wipe it dry.
Caution: Do not pour water directly on your appliance near the compressor area
** Use a damp cloth wrung out in a solution of one teaspoon of bicarbonate of soda to one pint of water
to clean the interior and wipe it dry.
** Excess deposit of ice should be removed on a regular basis using a plastic ice scraper available from
your local store. Large accumulation of ice will impair the performance of the freezer.
** If the freezer is not going to be used for a long period of time switch it OFF, remove all food, clean it
and leave the lid ajar.
**Check lid seals regularly to ensure they are clean and free from food particles.
Important Notes:
Never use water wash the compressor position, wipe it with a dry cloth thoroughly after cleaning to
prevent rust.
9
Advertisement
Table of Contents
