System Configuration - Epson RX8010SJ Applications Manual

15.5. System configuration

All ports connected to the I
connections to multiple devices.
SCL and SDA are both connected to the V
at high level when the bus is released (when communication is not being performed).
V
DD
SDA
SCL
Any device that controls the data transmission and data reception is defined as a "Master".
and any device that is controlled by a master device is defined as a "Slave".
The device transmitting data is defined as a "Transmitter" and the device receiving data is defined as a receiver"
In the case of this RTC module, controllers such as a CPU are defined as master devices and the RTC module is
defined as a slave device. When a device is used for both transmitting and receiving data, it is defined as either a
transmitter or receiver depending on these conditions.
RX8010SJ
ETM37E-07
2
C-Bus must be either open drain or open collector ports in order to enable AND
line via a pull-up resistance. Consequently, SCL and SDA are both held
IO
Master Slave
Transmitter/ Transmitter/
Receiver Receiver
CPU, etc. RX8010
Seiko Epson Corporation
15. The I2C-Bus Interface
Master Slave
Transmitter/ Transmitter/
Receiver Receiver
2
Other I C-Bus device
Jump to INDEX
38