Pro-Form PERFORMANCE 600i User Manual page 10

4. Set the Right Upright (79) on the Base (88) as
shown. Make sure not to pinch the Upright
Wire (80). Slide the Right Upright so that the
3/8" x 2 3/8" Screw (2) in the Base is inserted
into the slot (E) in the Right Upright. Do not
tighten the Screw yet.
5. Attach the Right Upright (79) to the Base (88)
with a 3/8" x 2 3/8" Screw (2), a 3/8" x 1 1/4"
Screw (4), a 3/8" x 1 1/2" Screw (3), and three
3/8" Star Washers (6) as shown; do not fully
tighten the Screws yet.
Attach the Left Upright (not shown) as shown
in steps 4 and 5. Note: There are no wires on
the left side.
6. Remove and save the four indicated 5/16" x
3/4" Screws (13) (only one side is shown).
Next, identify the Left and Right Base Covers
(94, 95). Slide the Left Base Cover onto the Left
Upright (78), and slide the Right Base Cover
onto the Right Upright (79). Do not press the
Base Covers into place yet.
4
5
88
6
4
79
6
78
94
10
80
E
2
88
2
6
3
6
13
79
79
95