Page 1
Christie Vive Audio LS3S Speaker U s e r M a n u a l 020-101269-01...
Page 3
Christie Vive Audio LS3S Speaker U s e r M a n u a l 020-101269-01...
Page 4
The warranty does not apply to any product where the serial number has been removed or obliterated. The warranty also does not apply to any product sold by a reseller to an end user outside of the country where the reseller is located unless (i) Christie has an office in the country where the end user is located or (ii) the required international warranty fee has been paid.
Page 5
Addendum Translated copies of this document are provided on the CD in the back of this document. The CD may also contain additional product documentation. Read all instructions before using or servicing this product. 本 文档 的翻译副本在本文档背面的 C D 上提 供。 该 CD 中还 可能 包含 其他 产品 文 档...
Earplugs or protectors to the ear canals or over the ears must be worn when operating this amplification system to prevent permanent hearing loss, if exposure is in excess of the described limits. Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
Observe load ratings and all applicable local safety codes. • Only use attachments or accessories specified by Christie. • To reduce the risk of system damage, turn off the power amplifier and then disconnect the speaker wire before performing a repair or maintenance.
This table lists the components that are shipped with the LS3S. Quantity Description Part number Christie LS3S line source surround speaker 145-107109-XX Christie LS3S line source surround speaker with grill 145-129103-XX Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
2. Connect the speaker wire to the positive (A) and negative (B) terminals on the back of the speaker. Use a #8 spade lug (part number: 145-159106-XX) if you are creating crimped spade lug terminations. Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
111-681207-XX Wall mount bracket (MM-060) 111-682208-XX 3. Mount the speaker to the wall using the manufacturer documentation provided with the bracket or the Christie Vive Audio BKW-SUR User Manual. Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
Page 13
Installation LS3S speaker Wall mount bracket Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
• Reroute audio cables away from AC power and lighting cables. • Verify correct gain structuring of B Chain and input and output levels of source devices and amplifiers. • Check the polarity. Christie Vive Audio LS3S Speaker User Manual 020-101269-01 Rev. 1 (03-2015)
89 dB Sensitivity , 1 W/1 m Recommended amplifier power 125 W - 250 W (FTC) at 4 Ohms / Christie CDA3 or Christie CDA5 (depending on application) Rated impedance 4 Ohms LS3S was measured in 2pi conditions. Such conditions most closely match typical indoor wall mount applications.
Need help?
Do you have a question about the Vive Audio LS3S and is the answer not in the manual?
Questions and answers