Table of Contents
Advertisement
Quick Links
14 Aug 2023
TABLE OF CONTENTS:
1.00
BEAMS & CONNECTORS:
1.10
1.20
1.30
2.00
2.10
2.20
3.00
3.10
3.20
3.30
3.31
3.40
3.41
3.42
3.43
Revision History:
Date
email:
info@matsing.com
MS-24C180-I
Date
Prepared by
Ray Ling
INSTRUCTION MANUAL MS-24C180-I
Description
website:
Instruction Manual
Approved by
Pavel
www.matsing.com
Document nos
MS-24C180I-IM-001
Revision
Revised by
nos.
Page
Revision
0
1
/
7
Advertisement
Table of Contents
Related Manuals for Matsing MS-24C180-I
Summary of Contents for Matsing MS-24C180-I
- Page 1 Date Prepared by Approved by Document nos Revision 14 Aug 2023 Ray Ling Pavel MS-24C180I-IM-001 INSTRUCTION MANUAL MS-24C180-I TABLE OF CONTENTS: 1.00 BEAMS & CONNECTORS: 1.10 Plan View Resultant Beam Direction 1.20 Plan View Connector Layout 1.30 Connector Port Table 2.00...
- Page 2 1.00 BEAMS & CONNECTORS: 1.10 Plan View Resultant Beam Direction Page...
- Page 3 1.20 Plan View Connector Layout 1.30 Connector Port Table Page...
- Page 4 2.00 BEAM PATTERN 2.10 Horizontal Beam Pattern 3700 - 4000 MHz Frequency: 2.20 Vertical Beam Pattern Frequency: 3700 - 4000 MHz...
- Page 5 3.00 TRANSPORTATION / INSTALLATION 3.10 Transportation (From Point to Point) Strictly comply to the Local authority and regulatory on Workplace Safety and Health Control and Measure when moving and transportation of large or heavy equipment, appropriate material handling machine should be use. (Risk Assessment apply for Forklift or Pallet Truck Lifting) 3.20 Bracket Mounting...
- Page 6 3.30 Installation using a crane Strictly comply to the local authority and regulatory on Workplace Safety and Health Control and Measure when performing lifting of large or heavy equipment, appropriate material handling machine should be used and only certified personnel should perform the task. (Risk Assessment requirement applies for both Up-Lifting and Down-Lifting.) 3.31 Lifting the Antenna...
- Page 7 3.40 Antenna Installation With reference to "Bracket Mounting" Procedure, End user is required to Custom-Make the additional supporting bracket and tighten it to the existing Antenna bracket to meet the deployment needs. 3.41 Antenna Levelling After the Antenna is mounted to the bracket, it is required to be adjusted to 0˚ (Zero Degree) with ≤0.2˚...
Need help?
Do you have a question about the MS-24C180-I and is the answer not in the manual?
Questions and answers