Flex PD 2G 18.0-EC FS55 Operating Instructions Manual page 20

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
Speed preselection
CAUTION!
Change the speed only when the power tool
is stopped.
 Move the selector switch to the required
stage:
1: Low speed, high torque
2: High speed, low torque
Switching on the power tool
To switch the power tool on:
 Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
 Release the trigger switch.
NOTE
The power tool is equipped with a brake
which stops the cutting accessory as
soon as the trigger switch is released.
When using the power tool continuously,
the operator should work primarily with
the trigger switch fully depressed.
Workplace lamp on/off switch
1. Turn direction of rotation preselector
switch (2) to "Forwards" or "Reverse".
2. Press electric tool on/off switch (1)
– Workplace lamp lights up
20
3. Release electric tool on/off switch (1)
– Workplace lamp goes out
automatically after approx. 10 sec.
Working with the power tool
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
NOTE
To facilitate handling of the appliance when
inserting screws, the screwdriver bit can be
inserted directly into the tool holder of the
appliance.
1. Assemble the tool head.
2. Insert the battery.
3. Insert the tool (drill bits, srewdriver bits,
bit holders).
4. Set operating mode according to the
work item.
5. Set torque preselection to the required
setting.
6. Set speed to the required setting.
7. Set the required direction of rotation.
8. Hold the power tool with one hand on the
handle and assume the working position.
If the power tool is running, never actuate
the direction preselector switch or torque
setting turning dial.
9. Switch on the power tool.
PD 2G 18.0-EC FS55

Advertisement

Table of Contents
loading

Table of Contents