Table of Contents
Advertisement
8. With the help of a second person, hold the con-
sole assembly (F) near the Right Upright (86).
Next, insert the Upright Wire (88) through the
indicated looped tie (G).
Connect the Upright Wire (88) to the wire (H)
from the console assembly (F). The connectors
should slide together easily and snap into
place with an audible click. If they do not,
turn one connector and try again.
Then, remove any wire ties (A) from the Upright
Wire (88).
9. Set the console assembly (F) on the Handrails
(81); do not pinch any wires.
Attach the console assembly (F) with the four
1/4" x 1/2" Screws (24) that you removed in step
7 and four 1/4" Star Washers (10); start all four
Screws, and then tighten them.
Insert the excess Upright Wire (88) into the Right
Upright (86). Then, tighten the tie (G) around the
Upright Wire and cut off the end of the tie.
8
F
87
86
9
F
81
G
88
10
24
86
12
H
G
88
A
10
24
81
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TRAINER 8.5 and is the answer not in the manual?
Questions and answers
My Proform ifit 8.5 treadmill (model PFTL76807.1) turns on but the buttons won't work. When you press any button it generates beeping, but no action.
If the Pro-Form Trainer 8.5 treadmill turns on but only beeps when buttons are pressed, the most likely causes could be:
1. The key is not properly inserted into the console.
2. The console may not be in manual mode or may require an iFIT card if using iFIT features.
3. There may be a console malfunction or software issue.
Check that the key is fully inserted, switch to manual mode if needed, and ensure the console is functioning properly.
This answer is automatically generated