Table of Contents
Advertisement
4. Hold the Right Upright (86) against the Base
(97). Make sure not to pinch the Upright
Wire (88).
Insert two 3/8" x 2 3/8" Screws (3) with two 3/8"
Star Washers (11) into the top of the bracket on
the Right Upright (86). Partially tighten the two
Screws into the Base (97); do not fully tighten
the Screws yet.
Then, partially tighten a 3/8" x 1 1/4" Screw
(1) and a 3/8" x 1 3/4" Screw (2) with 3/8"
Star Washers (11) into the bottom of the
Right Upright (86); do not fully tighten the
Screws yet.
Attach the Left Upright (not shown) in the
same way. Note: There are no wires on the left
side.
5. Identify the Left and Right Base Covers (93, 92).
Slide the Left and Right Base Covers onto the
Left and Right Uprights (85, 86) as shown.
4
97
11
1
86
5
85
93
10
3
11
88
2
11
86
92
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TRAINER 8.5 and is the answer not in the manual?
Questions and answers
My Proform ifit 8.5 treadmill (model PFTL76807.1) turns on but the buttons won't work. When you press any button it generates beeping, but no action.
If the Pro-Form Trainer 8.5 treadmill turns on but only beeps when buttons are pressed, the most likely causes could be:
1. The key is not properly inserted into the console.
2. The console may not be in manual mode or may require an iFIT card if using iFIT features.
3. There may be a console malfunction or software issue.
Check that the key is fully inserted, switch to manual mode if needed, and ensure the console is functioning properly.
This answer is automatically generated