Maintenance; Storage; Customer Responsibilities; Before Each Use - Craftsman 358.748200 Operator's Manual

CUSTOMER RESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
CARE
& MAINTENANCE TASK WHEN TO PERFORM
Check for loose fasteners and parts Before each use
Check for damaged or worn parts Before each use
Inspect and clean unit and labels After each use
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover
items that have been subjected to oper-
ator abuse or negligence. To receive full
value from the warranty, the operator
must maintain unit as instructed in this
manual. Various adjustments will need
to be made periodically to properly
maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
• Blower Tube
CHECK FOR DAMAGED OR
WORN PARTS
Contact your Sears Service Center for
replacement of damaged or worn
parts.
• ON/OFF Switch - Ensure switch func-
tions properly by moving the switch to
the OFF position. Make sure motor
stops; then restart motor and continue.
AFTER EACH USE
INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension cord.
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit using a damp cloth.
• Wipe off unit with a clean dry cloth.
PARTS AVAILABLE
Blower Tube ........... 530404358
Safety Glasses ......... 71-85707
Extension Cord ......... 71-85709
_WARNING: Perform the following
steps after each use:
• Stop unit and disconnect from the
power source.
• Allow motor to cool before storing or
transporting.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
• Store unit unplugged, well out of the
reach of children.
SEASONAL STORAGE
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
If your blower is to be stored for a peri-
od of time:
• Stop unit and disconnect from the
power source.
• Clean the entire unit.
• Clean air vents and air inlet of debris.
• Store your unit and extension cord in
a well ventilated area and covered, if
possible, to prevent dust and dirt ac-
cumulation. Do not cover with plastic.
Plastic cannot breathe and may
cause condensation and eventual
rust or corrosion.
• Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.