Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Transcoder Menu Commands
The following subsections describe how to access and use the Transcoder Menu commands.
Note: Refer to the Installation & Setup Guide for the applicable transcoder cards for further
information on transcoder configuration options.
Access the Transcoder Menu
1. Access the HCS6320 Main Menu as described on page 30.
[Main] Command > prompt, type card and press Enter.
2. At the
Enter card number (1-12) > prompt, type the chassis slot number of the
3. At the
transcoder card for which you wish to access configuration options. Then, press Enter.
The system identifies the card type and then displays a command prompt for the card
menu, for example:
Card #1 is: HCS7720
[HCS7720 (1)] Command >
Command > prompt, either:
4. At the
• Press Enter to display the card menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the
Menu.
Example: Transcoder Menu
------------
HCS7720 Menu
------------
hwid
Read Hardware ID
ver
Read Software Versions
bits
Read MUX Bitrates
pi
Install PI Key
pr
Reload PI Key
cksum
Read PI Key Checksum
stb
Satellite Receiver Menu
upd
Update Firmware
irst
Internal Reset
ret
Return to Main Menu
[HCS7720 (1)] Command >
206-4183
Command > prompt to display the Transcoder
Get other manuals https://www.bkmanuals.com
39
Advertisement
Table of Contents
