Related Manuals for LG CodePlus HCS6150R Series
Summary of Contents for LG CodePlus HCS6150R Series
- Page 1 HCS6150R CodePlus Series ™ Card Frame with Power Supply Installation & Setup Guide Warranty P/N: 206-4138 (Rev C) © Copyright 2012 LG Electronics U.S.A., Inc.
-
Page 2: Safety Warnings
CAUTION: Do not attempt to modify this product in any way without written authorization from LG Electronics U.S.A., Inc. Unauthorized modification could void the user’s authority to operate this product. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Important safeguards for you and your new product THIS PRODUCT HAS BEEN MANUFACTURED AND TESTED WITH SAFETY IN MIND. IMPROPER USE, HOWEVER, CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. TO AVOID DEFEATING THE SAFEGUARDS THAT HAVE BEEN BUILT INTO THIS PRODUCT, PLEASE READ AND OBSERVE THE FOLLOWING SAFETY POINTS WHEN INSTALLING AND USING THIS PRODUCT. - Page 4 23. Replacement Parts 20. Test Equipment When replacement parts are required, be sure In some cases, LG has supplied or recom- the service technician uses replacement parts mended the use of test equipment and devices specified by the manufacturer or that have the for the setup and testing of the equipment.
- Page 5 IMPORTANT SAFETY INSTRUCTIONS C. Circuit Overloading (Continued from previous page) Consideration should be given to the connection HCS6150R Rack Installation (also see pages of the equipment to the supply circuit and the 12-13) effect that overloading of the circuits might have on overcurrent protection and supply wiring.
-
Page 6: Table Of Contents
Table of Contents / Setup Checklist Table of Contents Safety Warnings ..... . . 2 Front Panel Overview / Ventilation ..11 Important Safety Instructions. -
Page 7: Hcs6150R Product Description
HCS6150R CodePlus Series Card Frame with Power Supply The HCS6150R is a 19-inch rack-mountable card frame that provides the operating environment for the LG HCS7700, HCS7710, or HCS7720 CodePlus series transcoder cards. Using one or more HCS6150R units containing appropriate transcoder cards, a variety of transcoding systems can be realized. -
Page 8: Back Panel Overview
Back Panel Overview The following figure shows a typical installation with all the available card slots filled. HCS6400 HCS7700 HCS7700 HCS6400 HCS7700 HCS7700 HCS6400 HCS6300 HCS6400 HCS7700 HCS7700 HCS7700 HCS7700 ETHERNET ASI OUT ASI OUT ASI OUT ASI OUT ASI OUT ASI OUT ASI OUT ASI OUT... - Page 9 Back Panel Overview (Cont.) Output/Terminal Marking The following ratings must be observed when cards are added to the HCS6150R. Marking Location Voltage (VDC) Amperage (A) For Card Slot numbers: 1, 2, 4, 5, 8, 9, 11, and 12 For Card Slot numbers: 3, 6, 7, and 10 For Card Slot: CONTROLLER 1.35 Important Card Slot Information...
-
Page 10: Installing Codeplus Transcoder Cards
2. Select the slot(s) in the card frame in which to install the transcoder card(s). Note: All cards must be used in an LG-approved card frame for this product. 3. If applicable, remove the HCS6150R AC power cord from the power outlet. -
Page 11: Front Panel Overview / Ventilation
Front Panel Overview / Ventilation The following figure shows the HCS6150R front panel. Back panel features are described on pages 8 to 9. Back Front Bottom Ventilation Holes Air flow must not be obstructed. To ventilate the system normally and avoid overheating, leave at least 1 inch (2.5 cm) on each side of the HCS6150R unit. -
Page 12: Rack Installation
Rack Installation Typical Rack Installation 1. Carefully slide the card frame with cards into a standard 19-inch equipment rack. 2. Use all four mounting screws to secure the chassis to the rack. Install HCS6150R unit in rack. HCS 770 HCS 770 HCS 640 HCS 770 HCS 770... - Page 13 Rack Installation (Cont.) B. Reduced Air Flow Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised. To ventilate the system normally and avoid overheating, leave at least 1 inch (2.5 cm) on each side of the HCS6150R unit. Do NOT stack other equipment on the top of the HCS6150R unit.
-
Page 14: Equipment Setup Review / Specifications
Equipment Setup Review / Specifications Equipment Setup Review • Make sure all connectors and connections are tight and secure on all entertainment system components. • Check to make sure each device supplying the signal to a transcoder card is functioning properly. -
Page 15: Document Revision History / Notes
Document Revision History / Notes Document Revision History Date Description February 2010 Revision A: New document March 2010 Revision B: Safety Instructions update July 2012 Revision C: Transcoder updates Product documentation is available online at: www.LGsolutions.com/products. From the Products page, select TVs, Systems & Solutions, then Head End Systems, then CodePlus Transcoder Series (click Show [+] to view the list of products), then the applicable Modular System option. -
Page 16: Warranty
Broadcast Products Welcome to the LG family! We believe that you will be pleased with your new HCS6150R Card Frame with Power Supply. Please read this warranty carefully, it is a “LIMITED WARRANTY” as defined under Federal Law. This warranty gives you specific legal rights, and you may also have other rights that vary from state-to-state within the U.S.A.