Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Set the HCS6320 IP Address
1. Access the HCS6320 Main Menu as described on page 30.
[Main] Command > prompt, type setip and press Enter.
2. At the
Using DHCP (y/n)? prompt, either:
3. At the
• Type y and press Enter if using DHCP. The system will display:
set .
Go to step 5.
• Type n and press Enter to assign a static IP address to the HCS6320. Then, continue
with step 4.
4. At each of the following prompts, type the information requested. Press Enter after each
entry.
Enter IP address:
Enter Subnet Mask:
Enter Gateway:
(Type the IP address of the default gateway in the format xxx.xxx.xxx.xxx.)
Once you enter the gateway address, the system will display:
set.
5. Reset the HCS6320 card (see "Perform an External Card Reset" on page 32). IP settings
will not take effect until the HCS6320 resets.
Note: If you intend to modify additional configuration settings during the current session,
you may wait until all changes are complete before you reset the HCS6320.
Install a Pro:Idiom Key on All Transcoders
The Pro:Idiom encrypter built into the transcoder cards contains a default encryption key. When
first installed, the cards will use this key to encrypt content. This command enables you to
change the encryption key, if necessary.
This command installs the Pro:Idiom key on all the transcoders installed in the chassis. To
install a Pro:Idiom key on a single transcoder, see "Install a Pro:Idiom Key on the Selected
Transcoder" on page 40.
Note: In order for a Pro:Idiom encrypted channel to be displayed, the receiver
must contain a Pro:Idiom decrypter, and the receiver must be configured to allow
decryption of the desired channel.
Note: The process of updating the encryption key will synchronize the decryption
key in any receiver tuned to the cards' output. If the target receiver is turned off or
viewing content from a different card, the synchronization will not occur, and the
output will be scrambled. Ensure that all encrypters and decrypters in a system
are synchronized to the same key.
206-4183
(Type the host IP address in the format xxx.xxx.xxx.xxx.)
(Type the subnet mask in the format xxx.xxx.xxx.xxx.)
Get other manuals https://www.bkmanuals.com
IP address has been
IP address has been
33
Advertisement
Table of Contents
