Sony FD Trinitron WEGA KV-27FS210 Operating Instructions Manual page 26

01US01COV-BR2.book Page 18 Wednesday, April 23, 2003 2:44 PM
Operating Instructions
Connecting a TV, VCR, and Satellite Receiver
1
Satellite receiver
1
Connect the coaxial cable from your satellite antenna to SATELLITE IN on the satellite
receiver.
2
Connect the coaxial cable from your cable service or antenna to the IN jack on your VCR.
3
Using a coaxial cable (not supplied), connect the OUT jack on your VCR to the VHF/UHF
jack on your TV.
4
Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your satellite
receiver to AUDIO/VIDEO IN on your VCR.
5
Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your VCR to
AUDIO/VIDEO IN on your TV.
✍
To view from the satellite receiver or VCR, select the video input to which your satellite receiver or
VCR is connected by pressing
Using your TV with this connection
This connection allows you to do the following:
❏
Program your Sony remote control to operate your VCR or satellite receiver (see page 5).
❏
Turn on your VCR to enable your satellite receiver to work with this connection.
❏
To activate your remote, press
receiver.
❏
Press repeatedly to switch between VCR input (VIDEO input), VHF/UHF
(local channels or unscrambled), or your cable box (cable system or scrambled channels).
18
4
From
cable/
antenna
2
VCR
5
on the remote control.
to operate your VCR or
Rear of TV
1 3 4 5
AUDIO OUT
(VAR/FIX)
Y
S VIDEO
P
B
P
R
VIDEO
L L
(MONO) (MONO)
R R
3
to operate your satellite
Video (yellow)
Audio L (white)
Audio R (red)