Programming The Remote Control - Sony FD Trinitron WEGA KV-27FS210 Operating Instructions Manual

01US01COV-BR2.book Page 5 Wednesday, April 23, 2003 2:44 PM

Programming the Remote Control

In order to use your remote control with other equipment, you need to program your remote
control. Use the following procedure to program the remote control.
1
Check the list of "Manufacturer's Codes" on page 6 and find the three-digit code number
for the manufacturer of your component. If more than one code number is listed, use the
number listed first.
2
Press .
✍
The and
3
Press or
the remote control.
✍
You must do step 4 within 10 seconds of step 3, or you must redo steps 2 and 3.
4
Use the buttons to enter the three-digit manufacturer's code number.
0 9
5
Press .
6
To check if the code number works, aim the TV's remote control at the component and
press on the green POWER button that corresponds with that component. If it responds,
you are done. If not try using another code listed for that manufacturer.
✍
If you have problems programming your remote control, see "Troubleshooting" on page 43.
button will flash when you press
button to indicate the type of component you want to program with
Using the Remote Control
.
5