Fein CCG18-125-10 AS Instruction Manual page 23

Adjustments.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Adjusting the wheel guard (figure 8).
Release clamping lever.
Turn the wheel guard to the requested
working position, then clamp the wheel
guard with the clamping lever.
Allow the clamping lever to engage.
Illumination (figure 9).
Never look or stare into the
WARNING
light of the power tool's lamp
from a short distance. Never point the light
of the lamp into the eyes of other persons in
close vicinity. The radiation produced by the
lamp can be harmful for the eye.
When pressing the On/Off switch, the light
is switched on.
After releasing the On/Off switch, the light
briefly stays on and then switches off auto-
matically.
Fig. 8
1.
2.
Fig. 9
23
en
Clamping lever
=
=