Operating Easy Pairing; Sharing Your Location - Motorola TALKABOUT T802 Series User Manual

English
Note: You do not need to continue to hold the Emergency
button or use the PTT button to transmit your message.
3. After the alert tone ends, speak into the microphone.
• Your voice or incidental sounds is transmitted.
• Your radio speaker emits a Talk Confirmation Tone after 30
seconds. Operation then returns to the normal Two-Way mode.
• If your radio is connected to the Talkabout application when an
Emergency Alert is triggered, the S.O.S message that is pre-saved
in your Talkabout application is sent out to everyone in range that
has Talkabout application and is connected with the application.
You must have the Talkabout application connected to receive the
S.O.S message.
4. To customize the S.O.S message, refer to the Talkabout application
in radio setting.
Note: All Motorola Solutions Talkabout EM, MJ, MR, MT,
MU, T400, T500, T600, T800 series radio (except for the
T400 model) are fully compatible with the Emergency Alert
feature. Radios other than EM, MJ, MR, MT, MU, T400,
T500, T600, T800 series can receive the emergency alert
signal, but do not respond with adjusted volume settings,
locked controls, or a warbling alert tone. Users of other radio
models set to the same channel and Interference Eliminator
Code hear a steady tone for eight seconds followed by the
voice transmission for 22 seconds.
Warning: The Emergency Alert feature must only be used
in the event of an actual emergency. Motorola Solutions is
not responsible if there is no response to the emergency alert
from the receiving group.

Operating Easy Pairing

The Easy Pairing feature allows all radios in a group to be programmed
simultaneously to the same channel and Interference Eliminator Code.
14
Any one radio in the group can be set as the leader. The channel and
Interference Eliminator Code settings of the leader can be copied to the
other radios in the group.
1. Pick any radio as the leader. Program the channel and Interference
Eliminator Code to the desired settings on this radio.
See Selecting Channels on page 9 and
Eliminator Codes on page 10.
2. To copy the channel and Interference Eliminator Code combination
to all the other member radios, press and hold the Easy Pairing/
Location Sharing button on the member radios until you hear a
beep.
To program all the radios at the same time, the radios in the group
must perform these step at the same time.
The Easy Pairing icon blinks indicating that the radio is in Easy
Pairing Mode and waiting to receive the settings from the leader. The
radio stays in this mode for three minutes.
3. Release the button after the beep and wait for the transmission from
the leader radio.
4. On the leader radio, press and hold the Easy Pairing/Location
Sharing button until you hear a double beep.
At the double beep, the radios in the group copy the transmitted channel
and Interference Eliminator Code settings of the leader.
Note:
The leader radio must make this transmission when all the
member radios are still in the Easy Pairing mode. Otherwise
the transmission is not picked up.
The leader must not release the Easy Pairing button at the
first tone. Otherwise the radio becomes a recipient. If this action
happens, you must press the PTT button to escape and then
retry the step.

Sharing Your Location

To share and request a location update, perform one of the following
actions:
• Use the Talkabout application to set your preferences on sharing your
location.
Selecting the Interference