Operating Easy Pairing - Motorola TALKABOUT T800 Series User Manual

MN009246A01-AA
Chapter 5 : Advanced Features
3 After the alert tone ends, speak into the microphone.
• Your voice or incidental sounds is transmitted.
• Your radio speaker emits a Talk Confirmation Tone after 30 seconds. Operation then returns
to the normal Two-Way mode.
• If your radio is connected to the Talkabout application when an Emergency Alert is triggered,
the S.O.S message that is pre-saved in your Talkabout application is sent out to everyone in
range that has Talkabout application and is connected with the application. You must have
the Talkabout application connected to receive the S.O.S message.
4 To customize the S.O.S message, refer to the Talkabout application in radio setting.
NOTE: All Motorola Solutions Talkabout EM, MJ, MR, MT, MU, T400, T500, T600, T800
series radio (except for the T400 model) are fully compatible with the Emergency Alert
feature. Radios other than EM, MJ, MR, MT, MU, T400, T500, T600, T800 series can
receive the emergency alert signal, but do not respond with adjusted volume settings,
locked controls, or a warbling alert tone. Users of other radio models set to the same
channel and Interference Eliminator Code hear a steady tone for eight seconds followed
by the voice transmission for 22 seconds.
WARNING: The Emergency Alert feature must only be used in the event of an
actual emergency. Motorola Solutions is not responsible if there is no response to the
emergency alert from the receiving group.
5.7

Operating Easy Pairing

The Easy Pairing/Location Sharing button has dual functionalities. The Easy Pairing feature allows a
group of radio users to program all their radios to the same channel and Interference Eliminator Code
settings quickly and simultaneously. Anyone's radio within the group can be designated as the "Leader
radio" and have its channel and Interference Eliminator Code settings transmitted and copied by all the
other member radios in the group.
Procedure:
1 Pick any radio as the "Leader radio". Program the channel and Interference Eliminator Code
to the desired settings on this radio. See
Interference Eliminator Codes on page
2 Press and hold the button on the member radios until you hear a beep to copy the channel and
Interference Eliminator Code combination to all the other member radios. Release the button
after the beep, and wait for the transmission from the Leader's radio.
The Easy Pairing icon on the display blinks. This confirms that the radio is in the Easy Pairing
mode waiting to receive the channel and Interference Eliminator Code settings from the Leader's
radio. All member radios remain in this mode for 3 min.
NOTE: A group with many radios should have all users take this step at the same time,
so all radios can be programmed in one go.
26
Scanning Channels on page 27
18.
and Selecting the