Advertisement
Calibration Hole
™
• Turn Pixter® power on. Wait until you see the Home Screen.
• Turn Pixter over and locate the calibration hole.
• Insert, push and hold the stylus in the calibration hole. Turn Pixter® over
so that you can see the screen.
• When you see two
, remove the stylus from the calibration hole.
• First touch the
in the upper left corner with the tip of the stylus.
• Then, touch the
in the lower right corner with the tip of the stylus.
Hint: After calibrating your screen, the contrast resets to the mid-level.
To change the contrast on the screen, touch the Save It!
tool.
51
Advertisement
