Turning On The Headlight; During Operation; Starting The Machine; Activating Eco Mode - Toro 39915 Operator's Manual

Turning On the Headlight

You can turn on the power to the headlight before
operating the machine; turn the key to the A
position (Figure 12).
In the A position, you can also view the
CCESSORY
state of charge of each installed battery. The position
of each set of lights corresponds to the related battery
cavity. If the battery state of charge is too low and
needs to be charged, or if there is no battery in the
corresponding cavity, the battery presence light does
not turn on.
Figure 12
1. State-of-charge lights
2. Battery presence lights

During Operation

Starting the Machine

Note:
Use the battery pack only in temperatures
that are within the appropriate range; refer to
Specifications (page 14).
1. Ensure that the battery pack(s) are installed in
the machine; refer to
(page 14).
2. Insert the electric-start key into the control panel.
3. Turn the key to the A
4. Turn the key to the O
machine (Figure
Note:
If the key is turned from O
the O too quickly, the machine may not start;
N
ensure that the key stops briefly in the middle
A position.
CCESSORY
CCESSORY
3. Key switch in the
A position
CCESSORY
Installing the Battery Pack
position.
CCESSORY
position to turn on the
N
13).
position to
FF
1. Key switch in O
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way, it beeps to indicate
that the timeout was engaged.

Activating ECO Mode

g348182
Using ECO mode may extend battery life by reducing
rotor speed; use ECO mode whenever you are
moving light snow, or moving snow a short distance.
Activate ECO mode using the ECO button as shown
in Figure 14.
1. ECO mode button
15
Figure 13
position
N
Figure 14
g347864
g347866