Related Manuals for Toro 39922T Series
Summary of Contents for Toro 39922T Series
- Page 1 Form No. 3450-340 Rev A 21in Power Clear ® Flex-Force Power System ™ 60V MAX Commercial Snowthrower Model No. 39922T—Serial No. 400000000 and Up *3450-340* Register at www.Toro.com. Original Instructions (EN)
- Page 2 Whenever you need service, genuine Toro parts, or For assistance, please see additional information, contact an Authorized Service www.Toro.com/support Dealer or Toro Customer Service and have the model for instructional videos and serial numbers of your product ready. Figure 1...
-
Page 3: Safety Alert Symbol
Use only the battery pack specified by Toro. Using other accessories and attachments may increase the risk of injury and fire. - Page 4 Operate the machine only in good visibility and appropriate weather conditions. Charge the battery pack with only the battery charger specified by Toro. A charger suitable for Use extreme caution when reversing or pulling 1 type of battery pack may create a risk of fire the machine toward you.
- Page 5 Check with local codes for • Replace the battery pack with a genuine possible special disposal instructions. Toro battery pack only; using another type of battery pack may cause a fire or risk of injury. SAVE THESE •...
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal145-8253 145-8253 decal137-2257 137-2257 1. Warning—read the Operator’s Manual. 3. - Page 7 decal94-8072 94-8072 decal114-9035 114-9035 1. Cutting/dismemberment hazard of hand, impeller; cutting/dismemberment hazard of foot, auger—do not place your hand in the chute; remove the key and read the Operator’s Manual before performing maintenance. decal147-1787 147-1787 1. The combined Ah rating of 2.
-
Page 8: Unfolding The Handle
Setup Unfolding the Handle Parts needed for this procedure: Handle lock Handle knob Procedure g389401 Installing the Discharge Chute Parts needed for this procedure: Discharge chute assembly Hex washer head screw Chute handle Procedure g291515... -
Page 9: Product Overview
Contact your Authorized Service Dealer or authorized Toro 4. Chute handle 9. Bail distributor or go to www.Toro.com for a list of all 5. Battery-compartment lid 10. Rotor blades approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 10: Operation
Starting the Machine Operation Ensure that the battery pack (or battery packs) are installed in the machine; refer to Installing Installing the Battery the Battery Pack(s) (page 10). Pack(s) Insert the electric-start button into the electric starter (A of Figure Important: Use a battery pack only in Squeeze the bail and hold it to the handle (B... -
Page 11: Activating Eco Mode
Activating ECO Mode Removing the Battery Pack(s) from the Machine Using ECO mode may extend battery life by reducing rotor speed; use ECO mode whenever you are Lift up the battery-compartment lid. moving snow a short distance. Activate ECO mode using the ECO switch as shown in Figure Press the battery pack-latch to release the... -
Page 12: Adjusting The Discharge Chute And Chute Deflector
Adjusting the Discharge Clearing a Clogged Chute and Chute Deflector Discharge Chute To adjust the discharge chute, move the chute handle. If the machine is running but there is no snow coming out of the discharge chute, the discharge chute may To adjust the chute deflector (and therefore the height be clogged. -
Page 13: Maintenance
Maintenance Stop the machine, remove the electric-start button, remove the battery pack from the machine, and wait for all movement to stop before adjusting, servicing, cleaning, or storing the machine. Inspecting the Rotor Blades Service Interval: Yearly—Inspect the rotor blades and have an Authorized Service Dealer replace the rotor blades and scraper if necessary. - Page 14 Storage Important: Store the machine, battery pack, and charger only in temperatures that are within the appropriate range; refer to Specifications (page Important: If you are storing the battery pack for the off-season, charge it until 2 or 3 LED indicators turn green on the battery.
-
Page 15: Troubleshooting
5. The auger/impeller drive belt is loose 5. Install and/or adjust the auger/impeller or is off the pulley. drive belt; refer to www.Toro.com for servicing information or take the machine to an Authorized Service Dealer. 6. The auger/impeller drive belt is worn 6. - Page 16 Problem Possible Cause Corrective Action The LED indicator light on the battery 1. There is an error in the communication 1. Remove the battery pack from the charger is blinking red. between the battery pack and the battery charger, unplug the battery charger.
- Page 17 Notes:...
- Page 18 Notes:...
- Page 19 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.