Table of Contents
Advertisement
INSTALLATION
After unpacking the oven, make sure that it has not been damaged during transport and that the oven
door closes properly. In the event of problems, contact the dealer or your nearest After-sales Service. To
prevent any damage, only remove the oven from its polystyrene foam base at the time of installation.
To safely move the oven, use the handle provided in the accessories pack.
1.
Insert the handle securely into the lateral holes (Fig. 1)
2.
Lift the handle up as shown in Fig. 2
Fig. 1
PREPARING THE HOUSING UNIT
•
Kitchen units in contact with the oven must be heat resistant (min 90°C).
•
Carry out all cabinet cutting work before fitting the oven in the housing and carefully remove all
wood chips and sawdust.
•
After installation, the bottom of the oven must no longer be accessible.
•
For correct appliance operation, do not obstruct the minimum gap between the worktop and the
upper edge of the oven.
ELECTRICAL CONNECTION (only in some models)
Make sure the power voltage specified on the appliance dataplate is the same as the mains voltage. The
dataplate is on the front edge of the oven (visible when the door is open).
•
Power cable replacement (type H05 RR-F 3 x 1.5 mm
Contact an authorized service centre.
•
The oven is programmed to operate with power absorption above 2.5 kW (indicated by "HIGH" in the
settings) which is compatible with a domestic power supply above 3kW. If the household has a lower
power supply, the setting must be lowered ("LOW" in the settings). The table below details the
recommended electrical power settings for the various countries.
Country
Germany
High
Spain
Finland
High
France
Italy
Holland
High
Norway
High
Sweden
High
UK
Belgium
GENERAL RECOMMENDATIONS
Before use:
-
Remove protective cardboard pieces, protective film and adhesive labels from accessories, induction
plate and cooking vessel.
-
Remove the accessories from the oven. Position the induction plate at the third level and plug it in.
Place the cooking vessel on the induction plate and fill it in with 200g of water. Select the Top
Finishing function and run the oven for approximately one hour to eliminate the smell and fumes
from the insulating materials and protective grease.
Fig. 2
Setting
Low
High
Low
Low
High
2
) must be carried out by a qualified electrician.
EN4
Advertisement
Table of Contents
