Start Protection / Child Lock; Pause Or Stop Cooking - Whirlpool AMW 528 Instructions For Use Manual

START PROTECTION / CHILD LOCK

This automatic safety function is
activated one minute after the oven has
returned to "stand by mode".
To pause cooking:
The cooking can be paused to check, turn
or stir the food by opening the door. The
setting will be maintained for 10 minutes.
To continue cooking:
Close the door and press the Start
button ONCE. The cooking is
resumed from where it was paused.
Pressing the Start button TWICE will
increase the time by 30 seconds.
(c)
1(a)
2
1(a). Turn the multifunction knob to the zero
position.
2(b). Press the Select button (3 seconds)
until the left-hand digit (hour's) fl icker.
3. Turn the +/- knob to set the hours.
4. Press the Select button again. (The two
right hand digits (minutes) fl icker).
5. Turn the +/- knob to set the minutes.
6. Press the Select button again.
The Clock is set and in operation.
6
The door must be opened and closed e.g.
putting food into it, before the safety lock is
released. Else the display will show "door".

PAUSE OR STOP COOKING

If you don't want to continue
cooking:
Remove the food, close the door
and press the STOP button.
A beep will signal once a minute
for 10 minutes when the cooking is
fi nished. Press the STOP button or open the
door to cancel the signal.
Note: The oven will only hold the settings
for 60 seconds if the door is opened and
then closed after the cooking is fi nished.
CLOCK
4
3
(b) 6
5
Note: When the appliance is fi rst plugged in
or after a power failure, the display is blank.
If the clock is not set, the display will remain
blank until the cooking time is set.
If you wish to remove the clock from the
display once it has been set,
follow steps (a) & (b) and press the Stop
button (c).
To reinstate the clock, follow the above
procedure.
Keep the door open while setting
the Clock. This gives you 10 minutes
to complete the setting of the Clock.
Otherwise, each step must be
accomplished within 60 seconds.