Start Protection / Child Lock; Pause Or Stop Cooking - Whirlpool AMW 485 Instructions For Use Manual

Hide thumbs Also See for AMW 485:
Table of Contents

Advertisement

This automatic safety function is activated
one minute after the oven has returned to
"stand by mode".
To pause cooking:
The cooking can be paused to check, turn or
stir the food by opening the door. The setting
will be maintained for 10 minutes.
To continue cooking:
Close the door and press the Start
button ONCE. The cooking is resumed
from where it was paused.
Pressing the Start button TWICE will increase
the time by 30 seconds.
1 3
5
2
4
1. Press the Clock button (3 seconds) until the left-hand digit (hour's) fl icker.
2. Press the +/- buttons to set the hours.
3. Press the Clock button again. (The two right hand digits (minutes) fl icker).
4. Press the +/- buttons to set the minutes.
5. Press the Clock button again.
The Clock is set and in operation.
Note: When the appliance is fi rst plugged in or after a power failure, the display is blank. If the
clock is not set, the display will remain blank until the cooking time is set.
Note: The Stop button may also be used to enter clock setting mode (press 3 seconds).
6

START PROTECTION / CHILD LOCK

The door must be opened and closed e.g.
putting food into it, before the safety lock is
released. Else the display will show "door".

PAUSE OR STOP COOKING

If you don't want to continue
cooking:
Remove the food, close the door and
press the STOP button
A beep will signal once a minute
for 10 minutes when the cooking is
fi nished. Press the STOP button or open the
door to cancel the signal.
Note: The oven will only hold the settings for
60 seconds if the door is opened and then
closed after the cooking is fi nished.
CLOCK
Keep the door open while setting the Clock.
This gives you 10 minutes to complete the
setting of the Clock. Otherwise, each step must
be accomplished within 60 seconds.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents