Remaining Running Time Display; Onboard Computer; Timer Programming; End Of Programme - Bosch SMI69T25 Operating Instructions Manual

Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display 8.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).

Onboard computer

You can switch the onboard computer
(additional programme information) off
or on. Proceed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )"
until : ... is indicated on the digital
display 8.
4. Release both buttons.
The LED for button # flashes
and the digital display 8 displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display 8.
To change the setting:
1. By pressing the 3 button, you can
switch the on board computer
(additional programme
information) off :
2. Press START button )".
The set value is saved.
3. Close the door.
.
or on : .
Operating the appliance

Timer programming

You can delay the start of the
programme in 1 hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press the button ` + until
flaching in the timer programming
display X.
4. Press + or – button until the `
displayed time corresponds with your
requirements.
5. Press START button )", timer
programming is activated.
6. To delete timer programming `,
press the + or – button until
indicated on the digital display X.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.

End of programme

The programme ends when the value
appears on the digital display 8
:
and Finished appears in the display
window )2.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
en
is
is
.
is
23