Table of Contents
Advertisement
en
Operating the appliance
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )*.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button X + until the digital
display )* jumps to œ:‹‚.
4. Press X + or – button until the
displayed time corresponds with your
requirements.
5. Press START button h, timer
programming is activated.
the X + or – button until )* œ:‹‹
6. To delete timer programming, press
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
24
End of programme
value ‹:‹‹ is indicated on the numerical
The programme has ended when the
display )*.
Automatic switch off after end
of programme or interior light*
* depending on model
To save energy, the dishwasher can be
automatically switched off 1 min or 120
min after the programme ends.
The setting can be selected from ˜:‹‹
to ˜:‹ƒ.
˜:‹‹ Appliance does not
switch off automatically.
The interior light 1"
comes on when the door
is opened irrespective of whether
the ON/OFF switch (
is switched on or off. When
the door is closed the light is off. If
the door is open for longer than 60
min., the light switches off
automatically. The interior light 1"
is lit only when the set value ˜:‹‹
is selected.
˜:‹‚ Appliance switches off after 1 min.
˜:‹ƒ Appliance switches off after 120
min.
A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t
Advertisement
Table of Contents
