Table of Contents
Advertisement
Rinse aid
R i n s e
As soon as the low rinse-aid indicator
P is lit on the fascia or is requested in
the display window )2, rinse aid
should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
a i d
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from
:
to :
. Please set rinse aid on
:
to obtain very good drying results
( :
is already set in factory).
Change this setting, only if streaks
(select lower setting) or water stains
(select higher setting) are left on the
utensils.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
: .... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display 8 displays the
factory setting :
5. Press programme button # until
the factory set value :
indicated on the digital display 8.
Rinse aid
en
.
is
13
Advertisement
Table of Contents
