Kenwood NEXEDGE NX-720 Series Instruction Manual page 16

4 Press the S or
5 Press the / key to select the status you want to transmit.
• If Manual Dialing is enabled, you can enter a station ID by using the DTMF
keypad. (refer to step 3, above).
6 Press the PTT switch or Side 2 key to initiate the call.
• "COMPLETE" appears on the display when the status has been successfully
transmitted.
■ Receiving
A calling ID or text message will appear when a Status call is received. Press any key
to return to normal operation.
■ Reviewing Messages in the Stack Memory
1 Press the key programmed as [Stack], or press and hold the key programmed as
[Selcall], [Status], or [Selcall + Status] to enter Stack mode.
• The last received message is displayed.
2 Press the / key to select the desired message.
• Message types are identified as follows:
ID: Caller ID, ST: Status Message, ME: Short Message
• Press and hold the S key for 1 second to cycle the display information as
follows:
ID Name > Status/Short Message > CH/GID
3 Press the Side 1 key to return to normal operation.
• To delete the selected message, press the A key. To confirm the deletion,
Press the S key.
• To delete all messages, press and hold the A or # key for 1 second. To confirm
the deletion, Press the S or
SHORT MESSAGES
This transceiver can receive short data messages which contain a maximum of 48
characters.
• Received short messages are displayed the same as Status messages. A maximum of
15 received messages (combined status messages and short messages) can be stored
in the stack memory of your transceiver.
GPS REPORT
To send your location data, you must first connect a GPS unit to the transceiver. GPS data
can be manually transmitted by pressing the key programmed as [Send the GPS data]. If
set up by your dealer, GPS data may be automatically transmitted at a preset time interval.
key to enter Status mode.
key.
11