PROFIX MEGA 66245 Operating Instruction page 5

Fig. 6
6. Aim the nozzle head (2) perpendicularly to the treated surface.
7. Prior to actual painting make several tests on a sample material until the
best result is achieved. Never leave the painting material inside the reservoir
Assembly drawing for the air blowing gun (exploded view):
Fig. 7
CHAPTER III. MANUFACTURER'S WARRANTY
The warranty specifically excludes all and any damages caused by regular
wear, overload or mishandling or application not in line with the intended
use for the specific tool. To keep the warranty valid the tool must be delivered
to the seller or to the service workshop in fully assembled condition.
The warranty covers spare parts to be replaced and workmanship over the
period of 12 months starting from the date of purchase confirmed by the
invoice of a cash register receipt and is valid only on the area of the Republic of
for further use as solidification of the material may lead to damage of the
tool, in particular its irreparable precise parts.
8. Carefully clean the tool interior after each use. To do so, fill the reservoir
with pure solvent, appropriate to the applied painting material and start
spraying in the environment-safe manner (aim the tool at a rag or at a
soaking material). Continue cleaning until the sprayed stream of solvent is
free of traces of the painting material. Use a cloth soaked with solvent to wipe
external parts of the gun where they are polluted with the applied painting
material. To clean the gun more accurately disassemble the tool according to
the foregoing assembly drawing. Immerse all the components into a
reservoir filled with pure solvent and then, with consideration to the
appropriate assembly procedure – put all the parts together after having
them perfectly dried.
CAUTION! Do never use the painting gun in confined rooms with cubic capacity
3
less than 30 m and without sufficient ventilation. Do never work with the gun
without an appropriate mask capable to protect the respiratory tract and eyes.
Poland. Possible defects can be remedied by replacement of the tool or
repairing the same.
During the warranty period shall repair the defective tool free of charge or
replace the defective unit or its malfunctioning components due to
manufacturing of them of inappropriate material or assembly defects arisen
by the fault of the manufacturer, provided that all requirements of the User's
Manual have been observed.
The equipment shall be repaired by service centers run by PROFIX or by
5
1. Clamping ring of the spraying nozzle
2. Nozzle head
3. Aerator
4. Needle socket
5. Nozzle body
6. Spacers
7. Screw
8. Pin
9. On /off trigger
10. Spacer for the paint feeding pipe
(option)
11. Paint feeding pipe (option)
12. Reservoir lid
13. Painting material reservoir
14. Spacer
15. Reservoir adapter
16. Fitting bolt
17. Bolt
18. Spraying rate controller
19. Spring
20. Nozzle needle
21. Trigger follower
22. Nut
23. Spacer
24. Spacer
25. Spring socket with thread
26. Spring
27. Inlet coupler
28. Controller for the spraying cone
29. Nut
30. O-ring